Measure-ups for existing houses

Do the measure-up once, on the tablet.

Walk through the house and sketch each room with your finger. It doesn't need to be neat. Then put in the lengths you measured, or send them straight from a Leica DISTO. Before you leave you can check the roof, the elevations and a 3D view, so you're not driving back for a missed wall.

$100 a month7-day free trial, no cardExports to DXF

What it does

Everything you need for a measure-up, with a tablet in one hand and a laser measure in the other.

✎

Sketch first, measure second

Draw a rough outline of the room, not to scale, then type in the lengths you measured.

⌁

Leica DISTO

Pair it with the tablet as a Bluetooth keyboard. Each reading goes straight into the wall length, then you pick which end of the wall moves.

⊞

Tidy up the numbers

Walls between neighbouring rooms that are within 200 mm become one shared wall, and small differences get shared out so everything fits.

▤

Decks and verandas too

Rooms, verandas, alfresco areas, porches, balconies and decks, with post spacing and balustrade height.

⌂

Levels, footings and roof

Up to four levels, on a slab, stumps or brick piers, with a pitched, skillion or flat roof and eaves. Hip roofs follow angled walls too.

◫

Elevations and 3D

Look at each elevation and spin the house around in 3D to spot anything you missed while you're still there.

⇩

DXF export

Export a DXF and carry on in AutoCAD, BricsCAD or whatever you use.

⟲

Saves as you go, syncs when it can

Everything saves on the tablet first, so no signal is no problem. Projects upload to your account when you're back online and open on your other devices. Anything not uploaded yet is clearly marked.

◇

Any shape of room

Sketch angled walls, drag a corner or type the exact angle, and add or remove corners for bays and notches. Generate hip roof works on them too.

≡

Stairs

Straight, L and U stairs, with winders or landings, including several landings on a long straight run. Riser and going sizes are checked against the NCC.

▣

Fireplaces, columns and voids

Block-outs against a wall or standing free in the room, with the gaps to each wall measured. Voids show where the floor is open.

⇄

Two devices, one project

Measure on the tablet, tidy up on the laptop. Changes from both are combined room by room, and if the same room was changed on both you choose which to keep.

How it works

Set the building up once, then go room by room.

Step 1

Set up the building

Ground level, floor height, footing type, how many levels and what sort of roof.

Step 2

Sketch and measure

Draw each room roughly, then put in the wall lengths by hand or from the DISTO.

Step 3

Check and export

Tidy the dimensions, have a look at the roof, elevations and 3D, then export the DXF.

Please check your measurements

Site Measure is a sketching aid. Sizes, roofs and elevations are approximate, so check everything before you rely on it, and have anything used for design or construction checked by a qualified person.

Try it on your next measure-up

The free trial runs for 7 days and covers one project with up to 5 rooms. You don't need a card to start.